Acoustical Panels with Fiberglass Core

PS80 Acoustical Panel
Acoustical Panels with Fiberglass Core

Some interiors don’t call for standard-shaped panels. When panels have to be altered to fit, the PS80 is the one for the job. Its 1″ or 2″ sound absorbing fiberglass core is surrounded by resin-hardened perimeter edges, is lightweight and can easily be cut to meet installation requirements. Special shapes and thicknesses are available in PS80, and radius, bevel and miter edges are offered in addition to the standard square edges.

INSTALLATION

PS80 acoustical panels may be affixed with factory installed Z-Clips, Hook and Loop fasteners, Adhesive, or Magnets (leveling angles provided).

PS80 Specifier - Panel & Use Reference

• Acoustical Panel Thickness & Covering changes NRC values, following is general guide.
• Our mill standard covering is Guilford of Maine FR701-2100 series.
• Covering MUST allow sound waves to travel thru the covering for any absorbing.
• NRC values shown are based on selection made for thickness, covering, and all other options.  Questions Inquire.
• Review Noise Coefficient Rating for Panel type / Thickness / Density / Covering found at bottom of page for each panel Type on web page Menu choices.

PS90+GL Acoustical Panel
Acoustical Panels with Fiberglass Core

When the area requires both Noise Reduction and a Tackable Surface and Panels offering Impact Resistance, then use PS90+GL Acoustical Panel. This is really the PS80 panel expanded!

Features:

• Panel has nominal 6-7 lb. density fiberglass core for sound reduction.
• Panel has added Glastrate, 1/8″ Fiberglass 18lb. density face sheet.
• Impact Resistance offered by the Glastrate• Panel
• Offered in either nominal thickness of 1 1/8″ or 2 1/8″
• Edges are resin hardened for choices of Square, Bevel, or Radius
• Installation by Z-Clip, Adhesive, or Hook & Loop methods, all with Leveling angles
• Tackable surface using the 1/8″ GL (Glastrate) works with push pins, to hold in place
• Covering or either Fabrics or Polyolefin works well
• Panel appears same as PS80 except for the extra thickness of the 1/8″ face sheet.

INSTALLATION

PS90+GL acoustical panels may be affixed with factory installed Z-Clips, Hook and Loop fasteners, Adhesive, or Magnets (leveling angles provided).

PS90+GL Specifier - Panel & Use Reference

• Panel Thickness & Covering changes NRC values, following is general guide.
• Our mill standard covering is Guilford of Maine FR701-2100 series.
• Covering MUST allow sound waves to travel thru the covering for any absorbing.
• NRC values shown are based on selection made for thickness, covering, and all other options.  Questions Inquire.
• Review Noise Coefficient Rating for Panel type / Thickness / Density / Covering found at bottom of page for each panel Type on web page Menu choices.